Memmert Model UNE 400.
30 °C to 220 °C. w x h x d: 550 x
680 x 480 mm
Standard equipment
Ventilation and
Control
- natural convection
- continuous adjustment of pre-heated fresh air
admixture
- vent connection with restrictor flap
- fuzzy-supported PID microprocessor controller with
integrated autodiagnostic system with fault indication
- solid state switching unit
- 2 Pt100 sensors Class A in 4-wire-circuit, mutually
monitoring and taking over the performance at the same temperature value
- digital 7-day-programme-timer with real time clock,
precise minute setting, for one set value or ramp operation in combination with:
- integrated digital timer for tempering profile with
max. 4 segments, each segment adjustable from 1 min to 999 hours:
- DELAYED ON
- HEATING UP
- HOLD or HOLD set-temperature-dependent with
guaranteed holding time
- COOLING DOWN
- "Loop" function to repeat profile 1-99 times or
endless
- digital display (LED) of all set parameters, such as
temperature, weekdays, time, programme status and set-up values
- resolution of display for set value 0,5 °C; for
actual value 0,1 °C below 99,9 °C, 0,5 °C above 100 °C
- long-term logging (ring store) of all relevant data,
GLP-conforming as data logger - 1024 kB
- serial interface RS 232 including MEMMERT Software
„Celsius 2007" for programming and documentation
- incl. works calibration certificate for +160 °C
Triple Overtemperature
Protection
- in case of overtemperature due to failure, the
heating is switched off at approx. 10 °C above the set temperature (fixed value)
- independently working, digitally adjustable
electronic overtemperature controller TWW protection class 3.1
- resolution of display and setting accuracy: 0,5 °C
below 99,9 °C, 1 °C above 100 °C
- mechanical temperature limiter TB protection class 1
switching the heating off at approx. 10 °C above max. oven temperature
Textured Stainless Steel
Casing
- w x h x d: 550 x 680 x 480 mm
- fully insulated stainless steel door with double
locking and 4-point adjustment
- rear zinc-plated steel
Interior - Heating
Concept
- w x h x d: 400 x 400 x 330 mm, 53 l
- easy-to-clean interior, made of stainless steel,
reinforced by deep drawn ribbing with integrated and protected large-area
heating on four sides
- 1 perforated stainless steel shelf, non-tipping
Temperature Range
- from +30 °C (however, at least 5 °C above ambient)
up to +250 °C
Voltage / Power Rating
- 230 V (+/- 10%), 50/60 Hz
- ca. 1,400 W (during heating)
- adaption of effective heating power depending
on the set temperature
|